MLU TO-02 R-R IC-F
0
- GSI Part
- 7005-150806
- Machine Make
- Tornos
- Machine Model
- SWISS GT26 / 386210 / T1 (cutoff) / 16x16mm
- Execution
- R
"
multidec® coolant-thru clamps/wedges directly replace the standard tool holder clamps/wedges on your Swiss machine's turning tool gang slide, providing high pressure coolant directly to the cutting zone without the use of special coolant-thru tool shanks. In addition, they feature adjustable stops for repeatable positioning of the tool holder after tool changes. A wide assortment of coolant accessories, such as quick-change connectors, tight bending steel-braided hosing, and manifolds are available to complete your high pressure coolant-thru setup.
- Works with ANY square shank Swiss tooling
- NEVER waste time bending and aiming coolant lines again
- Eliminates stringy chips from collecting on your cutting tools
- Right and left hand coolant jet patterns
- Provides a way to perform quick tool changes
- An assortment of quick connect coolant fittings, connections, and hoses available
Related Products
